SUGGESTED USES: Concrete floors, steel, equipment and anywhere a rugged industrial coating is needed.
LIMITATIONS: Surface temperature should be a minimum of 5 degrees above dew point. Protect uncured EPoxy coating from moisture, rain, running water until the coating is completely dry.
COLORS: Black, Blue, Gray, Green, Orange, Purple, Red, White and Yellow
VEHICLE TYPE: 100% Solid Epoxy Resin and Cycloaliphatic Curing Agent.
SOLIDS BY WEIGHT: 100%
VISCOSITY AT 25 DEGREES c: 7000cps
WEIGHT PER GALLON: 12 pounds per gallon (varies by color)
RECOMMENDED DRY FILM: 5.0 mils dry is 320 square feet per Gallon. Material losses during the mixing and application will vary and must be taken into consideration. Expect less coverage on bare, rough or sandblasted surfaces.
AVERAGE DRY TIME: 25 degrees C: Dries to touch in 4 hours. Lower temperatures & higher humidity will slow down dry times
RESISTANCE TO: Chemical Resistance, Abrasion, UV, Water, Oils, Grease
RECOMMENDED PRIMER: Self priming
APPLICATION: Brush, Spray, Roller or Squeegee
ROLL: short nap mohair metal, lambskin, phenolic core roller. Keep roller wet. Roll in one direction, re-wet, then cross roll.
SPRAY: Airless Spray. A single coat built up with a number of quick passes allows greater control over quantities, thickness and finish.
SURFACE PREPARATION: Remove all loose paint, dirt, oils and grease.
POT LIFE 1 hours at 25 degrees C.
SHELF LIFE: 1 year
MIXING: Mechanically mix for 10 minutes both part A & Part B individually, and then mechanically mix 10 minutes the combined volumes. Mix only what you expect to use in an 1 hour period.
PACKAGE: 2 Gallon pails, 5 gallon pails.
CLEAN UP: Airless equipment per manufacture recommendations.